Armasight Vulcan MG 3.March Tactical 3-24x42 FFP optical scope.KRISS Defiance low profile flip up rearsight īurris FullField TAC30 1-4x24 riflescope.KRISS Defiance low profile flip-up front sight.AK Taktika Tula TT01 rear sight Weaver adapter.P226 Sight Mount 220-239 rear sight bearing.P226 Meprolight TRU-DOT Night rear sight.P226 Meprolight TRU-DOT Night front sight.Magpul MBUS Gen2 rear flip-up sight (Flat Dark Earth).NcStar AR-15 Detachable Carry Handle 32.99. PRI AR-15 High Rider Carry Handle Mount 102.50. PRI M16/AR15 Standard Carry Handle Mount - A1/A2 Dual-Witness 98.00. Magpul MBUS Gen2 front flip-up sight (Flat Dark Earth) Weaver AR-15 Tri-Rail Carry Handle Mount 38.37.M14 Enlarged Military Aperture rear sight.Glock Dead Ringer Snake Eye front sight.Vortex RAZOR AMG UH-1 holographic sight.All aluminum construction and ready for abuse. Axion Kobra EKP-8-02 reflex sight (Dovetail) Easily add a rear sight with carry handle to any railed upper Fits standard picatinny mount 2 Apertures for both long rand precision and short range shooting Aluminum Construction Adjustable for windage and elevation Looking for that old school flair Our Rear Sight Carry Handle fits the bill perfectly.Trijicon ACOG TA01NSN 4x32 scope (Black).Leupold Mark 4 HAMR 4x24mm DeltaPoint hybrid assault scope.ELCAN SpecterDR 1x/4x scope (Flat Dark Earth).Leupold Mark 4 HAMR 4x24mm DeltaPoint hybrid assault scope LaRue LT101 QD tactical picatinny riser mount It's much, much, MUCH easier to rezero a slightly off optic when you're blasting for fun than it is rezeroing irons, especially in any type of match setting.Nightforce Magmount 34mm rings with Ruggedized Accessory PlatformĮLCAN SpecterDR 1x/4x scope (Flat Dark Earth)įLIR RS-32 2.25-9x 35mm 60Hz thermal riflescope It gives you every benefit- your irons remain locked in place for highpower, you have a relatively QD mount for your optic, and you can use the sights *with* the optic still attached. For all these reasons and from my own considerations, I again advise something like this:Ītop a standard A3 carry handle. I've done something very similar to all this, which is how I know it works. It's also so that you can use thinner or thicker posts at your discretion. This is so that you can set the proper zero (say 100y) with your rear at its mech.

The front sight would have to support standard A2-style front posts that could be lowered and elevated. Also, once in the up position, I would advise against putting it back down, but I think there's much less risk for zero shifting than by full removal.ģ. The front sight would have to be one that locks *solidly* in the up position, similar to the YHM ones. You also should not be removing it from the upper once a zero is established.Ģ. You could use a hooded sight with something like this. Supporting windage and up to 600y elevation in MOA-based increments. The rear would almost certainly have to be of the type I showed before:

For CMP/highpower, you would be okay with back up style sights under certain conditions:ġ.

A2 carry handle sight